Page 1 of 1


Posted: Wed Oct 18, 2017 9:30 pm
by jslick_007
I've seen some folks getting pretty good results using Linear Advance enabled on the Prusa i3MK2s. I see that LIN_ADVANCE is supported by the version of firmware posted in MakerGear's Github. I was wondering if it's actually enabled on the M3 version of the firmware and if it's really just a matter of setting appropriate "K" values for each filament in order to get it working to crank up the speed settings. Has anyone tried this on their MakerGear? I'm eagerly awaiting my M3ID to be delivered in a couple days, but before I started dialing everything in and converting all my processes over from my Mk2s, wanted to see if I should be doing it with linear advance or back to the "normal" tunes.