Duplication mode

The place to discuss the M3-ID
Post Reply
rcionni
Posts: 2
Joined: Sun Mar 18, 2018 6:08 pm

Duplication mode

Post by rcionni » Sun Mar 18, 2018 6:24 pm

I'm a new user on the M3-ID. Loving it so far when using the Octoprint slicer or the Simplify3d slicer and only using T0. However, when printing in duplication mode the print quality is awful. Uncertain as to why this is as I have installed the newest M3-ID duplication process files, leveled the bed and made certain that the hotends are calibrated to be within the Z distance from the bed required to allow for duplication mode. Does anyone know what I'm missing here?
...and...how do I attach a photo of my prints to this forum post?

alsted
Posts: 6
Joined: Fri Feb 02, 2018 9:34 am

Re: Duplication mode

Post by alsted » Tue Mar 27, 2018 12:55 pm

Hi

Sorry no help. But i have the same issues. Spend a few hours calibrating. Create a S3D duplication setup and then the see my prints turn in nothing but wasted hours and filament.

I can get it dual print the calibration cube with outproblems but once i add slightly larger stls to print it end really bad. Well i'm going to make a post on that later.

Best
Jens

Post Reply