my first dual color print

The place to discuss the M3-ID
Post Reply
User avatar
Umburry
Posts: 3
Joined: Fri Oct 30, 2015 3:35 pm

my first dual color print

Post by Umburry » Sun May 20, 2018 4:40 am

Wanted to share my 1st dual material part print. Was very easy to do. Just used the standard PLA profile provided by maker gear. Enabled prime tower in S3D. I don't think the tower was necessary, when the tool heads switched they started in the infill so any imperfections would have been hidden. I was a little worried about all the tweeking I would have to do to get the function working properly, but I got this right out of the box!
Whats everyone else's experience with dual material?
Image

sludgeogre
Posts: 2
Joined: Tue May 22, 2018 8:57 pm

Re: my first dual color print

Post by sludgeogre » Tue May 22, 2018 8:59 pm

Looks fantastic. My M3ID arrives on Friday and I have a bunch of Warmachine dual color tokens I'm very excited to make. I'll post them here once I finally get my machine up and running. :D

sludgeogre
Posts: 2
Joined: Tue May 22, 2018 8:57 pm

Re: my first dual color print

Post by sludgeogre » Wed May 30, 2018 9:59 pm

Image

Made a bunch of tokens! Took a while to figure out my process and it takes a lot longer than expected to push these out from a design standpoint (a lot harder than inkscape!!!) but the product you get is gorgeous and I love it!

Post Reply