Octopi doesn't like me anymore

The place to discuss the M3-ID
Post Reply
macmccaskie
Posts: 10
Joined: Sat Jun 09, 2018 6:19 pm

Octopi doesn't like me anymore

Post by macmccaskie » Sat Jun 09, 2018 6:31 pm

It was a short relationship. I promise I treated it with utmost respect!

I had just finished printing my key fob, what a difference the M#-ID was after my now boat anchor ANET A8. I started exploring octopi and noticed the "Registration" button.

Silly me, I followed instructions after clicking on Registration. Clicked Submit, then an email with an activation code.

Now Octopi is grayed out with a non-messaged message saying 'na'a when I click anywhere.

I even restarted it. Anyone with ideas how to get back into it's good graces?

Mac

macmccaskie
Posts: 10
Joined: Sat Jun 09, 2018 6:19 pm

Re: Octopi doesn't like me anymore

Post by macmccaskie » Sat Jun 16, 2018 9:34 pm

The problem turned out to be a setting issue shipped by the factory. If you are getting a new printer, do not register Octoprint until MakerGear issues an update.

Post Reply