The Place To Discuss MakerGear 3D Printers!
http://forum.makergear.com/
Ultimaker and M3-ID would be good choices. Ultimaker is 2.85mm diameter filament. M3-ID is a solid machineBelezeebub wrote: ↑Wed Jul 03, 2019 3:18 amI am looking to add a dual extruder printer to my farm I was thinking of Ultimaker 3/S5, raise 3d pro 2 or Taz pro but I found the MakerGear M3 Independent Dual Extruder 3D Printer - Rev 1 to be honest never heard if it and reviews are few and far between so I figured I would see what the users will say about it.
Have you used both? Do you like the M3 better?makeal wrote: ↑Sun Aug 04, 2019 11:23 pmUltimaker and M3-ID would be good choices. Ultimaker is 2.85mm diameter filament. M3-ID is a solid machineBelezeebub wrote: ↑Wed Jul 03, 2019 3:18 amI am looking to add a dual extruder printer to my farm I was thinking of Ultimaker 3/S5, raise 3d pro 2 or Taz pro but I found the MakerGear M3 Independent Dual Extruder 3D Printer - Rev 1 to be honest never heard if it and reviews are few and far between so I figured I would see what the users will say about it.