M3-ID trying to print on wrong toolhead
Posted: Sat Apr 04, 2020 8:47 pm
Hi,
I'm using S3D to slice, using the stock M3-ID Rev1 PETG profile, with 'Single Mode - Right Extruder (T1)' selected. When the model is sliced, the S3D preview screen shows all layers being printed with Tool1. However, when I upload the file to the printer via the web interface, the right (T1) extruder heats up, but all the move and print commands are being directed to Tool 0 (right). This results in a flood of 'cold extrusion' warnings which forces me to power cycle the printer to regain control (I can't shut the printer down using the web interface due to the flood of warnings).
Edit: I also just checked using the web interface, and manual X/Y movement commands to Tool1 do indeed move the correct (right-hand) head
I was just printing successfully with Tool 1 yesterday - WTF?
Frank
I'm using S3D to slice, using the stock M3-ID Rev1 PETG profile, with 'Single Mode - Right Extruder (T1)' selected. When the model is sliced, the S3D preview screen shows all layers being printed with Tool1. However, when I upload the file to the printer via the web interface, the right (T1) extruder heats up, but all the move and print commands are being directed to Tool 0 (right). This results in a flood of 'cold extrusion' warnings which forces me to power cycle the printer to regain control (I can't shut the printer down using the web interface due to the flood of warnings).
Edit: I also just checked using the web interface, and manual X/Y movement commands to Tool1 do indeed move the correct (right-hand) head
I was just printing successfully with Tool 1 yesterday - WTF?
Frank