I have an M3-ID and I just recently installed the BuildTak FlexPlate system. Now I'm trying to get the first layer right using the M3-ID's 'Starting Height Adjustment' feature. I print the zigzag, and it all comes off in one long string. So, I choose the Probe Offset Too Low choice and do it again. However, no matter how many times I do this, I keep getting the same result - the filament comes off in one long thread.
I have even tried the 'advanced' options, where I can choose the 'Large Adjustment' option. Same thing; no matter how many times I go through the procedure, I get exactly the same result. It appears the probe offset isn't increasing at all.
Any way to tell if the probe offset is actually increasing?
The place to discuss the M3-ID
1 post • Page 1 of 1