Probe Offset Procedure not working?

The place to discuss the M3-ID
Post Reply
paynterf
Posts: 28
Joined: Wed Sep 25, 2019 2:42 am

Probe Offset Procedure not working?

Post by paynterf » Sat Jan 09, 2021 3:46 pm

Hi,

I have an M3-ID and I just recently installed the BuildTak FlexPlate system. Now I'm trying to get the first layer right using the M3-ID's 'Starting Height Adjustment' feature. I print the zigzag, and it all comes off in one long string. So, I choose the Probe Offset Too Low choice and do it again. However, no matter how many times I do this, I keep getting the same result - the filament comes off in one long thread.

I have even tried the 'advanced' options, where I can choose the 'Large Adjustment' option. Same thing; no matter how many times I go through the procedure, I get exactly the same result. It appears the probe offset isn't increasing at all.

Any way to tell if the probe offset is actually increasing?

TIA,

Frank

Post Reply