Extruder not hot enough for petg

[johnr]

Hey guys, I'm using esun's black petg with my v3b extruder at 245 degrees. I'm wondering if I can go higher because it doesn't seem to be bonding to itself at all. Will it damage my nozzle if I go higher? Thanks.

[Jules]

First layer - 250°C, Second layer - 245°C. Turn off the fan to help with the bonding.

[jimc]

yes 245 should be getting that stuff to bond great but if the fan is on then keep in mind that will drop the nozzle temp a little even though its still reads 245. the temp reading is at the heater block not the nozzle so the fan will alter that temp. a fan can be used on small parts with quick layers.

[johnr]

Okay, I just barely tested it and it works fine. Thanks so much! I should have known to turn off the fan.

[Jules]

......I should have known to turn off the fan.

How would you have known, if it's your first shot at PETG?

Glad it worked though......have fun!