Page 1 of 1
3D printing muscles with Ninjaflex
Posted: Thu Dec 18, 2014 11:40 pm
by sprior
Just came across this article which talks about printing pneumatic muscles with NinjaFlex:
http://www.instructables.com/id/Soft-Ro ... /?ALLSTEPS
There goes the weekend...
Re: 3D printing muscles with Ninjaflex
Posted: Sun Dec 21, 2014 8:12 pm
by hybridprinter
saw this article, some pretty amazing stuff. have you gotten it to work? how is the Ninjaflex working for you? what extruder/hot end setup do you run?
Re: 3D printing muscles with Ninjaflex
Posted: Mon Dec 22, 2014 12:10 am
by sprior
I've printed NinjaFlex before, but haven't tried the muscles yet (busy weekend). I've got the prerelease V4 dual extruder upgrade, didn't have any luck extruding NinjaFlex with the V3B.