Another new M2
Posted: Wed Jan 14, 2015 1:12 am
I have been lurking in these forums for a couple months or so while I was narrowing down my choices of what 3D printer to buy to replace the workable-but-not-great one I built a couple years ago. I finally settled on the M2, and after I took the frame out of the box today there is no doubt in my mind I made the right decision. That thing is solid!
A large part of my decision was based off what I learned browsing through these forums, so I just wanted to give a quick thanks to all you helpful people. Happy printing!
A large part of my decision was based off what I learned browsing through these forums, so I just wanted to give a quick thanks to all you helpful people. Happy printing!