What went wrong with this PETG print???
Posted: Fri Oct 02, 2015 5:16 pm
Hi all,
So I printed 3DBenchy in 0.1mm with PETG and it all went to hell... http://imgur.com/a/vM1bE I stopped the print half way.
So then I tried exactly the same settings but at 0.3mm ... then it turned out quite okay. (See lower picture)
So why was it so poor at 0.1mm ???
Thanks,
loiphin.
So I printed 3DBenchy in 0.1mm with PETG and it all went to hell... http://imgur.com/a/vM1bE I stopped the print half way.
So then I tried exactly the same settings but at 0.3mm ... then it turned out quite okay. (See lower picture)
So why was it so poor at 0.1mm ???
Thanks,
loiphin.