MakerGear Forum

Posted: **Sat Mar 12, 2016 9:04 pm**

Just for fun, I recorded a thermal video of the HBP heating up and created a 30 second time-lapse:

https://www.youtube.com/watch?v=nVG_VjhfTRI

Blurb from YouTube:

Recorded with a FLIR ONE (the flashes/blips are the FLIR recalibrating itself).

I didn't tweak any emissivity settings so the indicated temperature will be off by a few degrees.

Posted: **Sat Mar 12, 2016 9:13 pm**

Interesting ! thanks for sharing !

Posted: **Sat Mar 12, 2016 10:36 pm**

On a related note:

It has come up a few times recently about how long it takes for a 24v Stock Makergear bed to come up to temp.

I timed the print I just started and it was 15.5 minutes to get to 100C. If someone wants to compare that to the alum beds then its out there.

MakerGear Forum

Thermal time-lapse video of M2 bed heating up

Thermal time-lapse video of M2 bed heating up

Re: Thermal time-lapse video of M2 bed heating up

Re: Thermal time-lapse video of M2 bed heating up