Accuracy and Nozzle diameter
Posted: Fri May 20, 2016 1:35 pm
Working on a few small parts, they are about 3/8" and I need the dimensions to come out as close to perfect as possible in order to fit together
I have been noticing with my .5mm nozzle, I am getting a decent amount of variance in parts, even in the same printing
I guess my question is 2 fold: will putting the .35" nozzle back on increase my accuracy any; and is the V4 any more accurate than the V3b?
I had it perfectly dialed in at one point, printed about 200 pieces, and then the variance went up again
I guess as a side note, what speed d you guys find that if you lower it to, the accuracy goes up, without it being so slow, it takes forever
Sorry for the long post, still learning here!
I have been noticing with my .5mm nozzle, I am getting a decent amount of variance in parts, even in the same printing
I guess my question is 2 fold: will putting the .35" nozzle back on increase my accuracy any; and is the V4 any more accurate than the V3b?
I had it perfectly dialed in at one point, printed about 200 pieces, and then the variance went up again
I guess as a side note, what speed d you guys find that if you lower it to, the accuracy goes up, without it being so slow, it takes forever
Sorry for the long post, still learning here!