replcement for the M2 glass?

[lfmdk]

Just owned the M2 and have been printing 24/7 in last few month, could not be any happier about it!

One thing I am wondering is if there is any place I can get another glass bed? so that I can swap the glass after print and immediately start a new one?

any help is appreciated!

thanks
Dell

[insta]

http://www.makergear.com/products/m-series-3d-printers -- look at the dropdown at the bottom, it has extra borosilicate glass.

Normal window glass will likely eventually shatter, but you can use it if you're brave.

[lfmdk]

Thanks a lot man! will order soon!

[Neep]

I recommend trying the zebra plate if you haven't. I switched to it and will never go back to glass. Adhesion problems are basically non-existent. The only concerns are keeping the thing flat after lots of use but I haven't had that problem.

[lfmdk]

looks promising! and better price, will try that out too!