Anyone have any thoughts as to why my outer perimeter layers don't seem to be adhering? Is there a setting I should adjust?
I print this bracket standing up just like the photo but on both the inside and out side the outer-most layer has pulled away. You may be able to notice it sticks out a little and I can press it down very easily....but it pops back out...
Any ideas? Thx!
PETG bracket outer sides not adhering
Re: PETG bracket outer sides not adhering
sure, you are underextruding. the extrusion width in real life isnt what you have it set to in the software.
Re: PETG bracket outer sides not adhering
Thanks! I recalibrate and am printing another bracket....