Brittle Black PLA

General discussion topics

Re: Brittle Black PLA

Postby insta » Thu May 11, 2017 5:32 pm

crazyg0od33 wrote:I appreciate that, but it aint "operator error" when the overlap was apparently near the end of the spool the entire time. Letting go of the filament wont snap it under about 6 strands at different layers on the spool.


Yeah, it will :) Retractions allow the tangle to shift down the spool.
Custom 3D printing for you or your business -- quote [at] pingring.org
User avatar
insta
 
Posts: 2001
Joined: Tue Sep 16, 2014 3:59 am

Re: Brittle Black PLA

Postby pyronaught » Wed May 17, 2017 1:51 am

Yep, the cross under point just migrates back and forth on the spool and can go for hours like that. Usually you can hear that something is wrong though because the spool will stick and release as this is happening. It's easy to save the print by cutting the filament, pulling out the cross under and then feeding it back into the extruder behind the cut piece.
Experience is what you get when you didn't get what you wanted.
User avatar
pyronaught
 
Posts: 669
Joined: Mon Dec 01, 2014 8:24 pm

Previous

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 4 guests