MakerGear Forum

I just recieved my 1/8 sheet and after cutting it to shape, I just replaced the glass with it. Does it need to be taped to the m2 plate or will the 4 corner tabs be enough. I already did a calibration of the bed and printed a calibration cube. Everything looks good. The main reason I ask is that the pei sheet was not perfectly flat, but looksfine mounted on the bed.

Thanks.

You'll likely need to test it and see. You can always get some of the sheet tape and add it later if it causes warping.

Remember to reset your gap.

Thanks for the reply.