Hello All,
New to the forum here and This is my third print on my new M2 V4
I thought everything was going very well until this started to appear after several hours
S3D
PLA
Bed at 70
Extruder at 215
Print speed at 4800
Layer at .2
Also will the printer go slower than 4800/minute?
Please explain how I post a photo so everyone can see what happened.
Thank you
Print Failed
- atomic_peach
- Posts: 37
- Joined: Sun Dec 04, 2016 2:14 am
- Location: Philadelphia, PA
Re: Print Failed
To upload a photo, use the "Upload Attachment" dialog seen below post editor window. Remember to click "Add the File" to actually add it to your post. You can then choose to "Place inline" to put it between post text, or leave it as is and it appears at the bottom like in this post.