I found my bed was always high in the middle and it turns out it was a bent X axis frame, low in the middle by 0.1mm.
I bought round shims from McMaster Carr and put them under the rail which fixed the issue.
Time for a new sheet of glass? Which thickness?
-
- Posts: 100
- Joined: Sat Apr 19, 2014 8:34 pm
Re: Time for a new sheet of glass? Which thickness?
Tolerances on glass aren't that tight. I have 3 glass plates all purchased around the same time. One of them needs a small Z-offset. Some variation is to be expected.
Thanks. Rechecked the glass and it's also much less than flat. Somehow had it "tuned" with old the M2. Ordering another plate.
Thanks. Rechecked the glass and it's also much less than flat. Somehow had it "tuned" with old the M2. Ordering another plate.
-
- Posts: 100
- Joined: Sat Apr 19, 2014 8:34 pm
Re: Time for a new sheet of glass? Which thickness?
Bought a new plate from Makergear. Works great.