Yesterday I printed a Benchy, and have been scraping through settings, trying to optimize things. I found some discussion about acceleration tuning, and I dumped my firmware settings for a baseline, thinking I might drop the rates a bit to improve quality and theoreticallyy reduce machine wear. To my surprise, the defaults were already quite low. Is this what is shipping in the M2 config now? (See below)
This was dumped from a freshly "booted" state on the M2, if that makes a difference. M501 shows the same thing, as expected.
Just looking for a sanity check here. I am currently at 900mm/s^2 and 1000mm/s^2 max for X and Y, respectively? Straight out of the box?
Code: Select all
Send: M503 Recv: echo:Steps per unit: Recv: echo: M92 X88.88 Y88.88 Z1007.70 E471.50 Recv: echo:Maximum feedrates (mm/s): Recv: echo: M203 X200.00 Y200.00 Z25.00 E25.00 Recv: echo:Maximum Acceleration (mm/s2): Recv: echo: M201 X900 Y1000 Z30 E2000 Recv: echo:Acceleration: S=acceleration, T=retract acceleration Recv: echo: M204 S2000.00 T3000.00 Recv: echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s) Recv: echo: M205 S0.00 T0.00 B20000 X4.00 Z0.40 E1.00 Recv: echo:Home offset (mm): Recv: echo: M206 X0.00 Y0.00 Z10.64 Recv: echo:PID settings: Recv: echo: M301 P25.89 I1.94 D86.53