Vendors selling MIC6/PEI specifically sized for M2.

General discussion topics
Post Reply
wiredinoc
Posts: 4
Joined: Tue Dec 30, 2014 9:09 am

Vendors selling MIC6/PEI specifically sized for M2.

Post by wiredinoc » Fri Jun 02, 2017 6:52 pm

Hi Community,

I'm having a heck of a time finding a vendor for a MIC6/PEI plate cut for M2. I'm sure this has been covered a million times, but I don't see anything too recent on the forums.

Thanks for the assist!

User avatar
insta
Posts: 2018
Joined: Tue Sep 16, 2014 3:59 am

Re: Vendors selling MIC6/PEI specifically sized for M2.

Post by insta » Fri Jun 02, 2017 7:10 pm

I have one left.
Custom 3D printing for you or your business -- quote [at] pingring.org

wiredinoc
Posts: 4
Joined: Tue Dec 30, 2014 9:09 am

Re: Vendors selling MIC6/PEI specifically sized for M2.

Post by wiredinoc » Fri Jun 02, 2017 7:13 pm

Cool, how do I get one?

If you only have one left, do you have a recommended vendor out there for additional?

User avatar
insta
Posts: 2018
Joined: Tue Sep 16, 2014 3:59 am

Re: Vendors selling MIC6/PEI specifically sized for M2.

Post by insta » Fri Jun 02, 2017 7:25 pm

If you're ok with a used one with some PETG stuck to it that I can't get off, I have two left ;)

Nobody else makes them, as far as I know. It's not *hard*, it just requires the right tooling, and to be cost / time effective you have to make like 20 at once.

Every now and then I'll make another batch of them when interest gets high enough.

Just email me -- email's in the signature.
Custom 3D printing for you or your business -- quote [at] pingring.org

Post Reply