MakerGear Forum

Just purchased a Raspberry Pi 3. I need some guidance on how to connect my M2 to the Rsspberry
Thanks

Here's how I did it:
https://octopi.octoprint.org/

Thank you for your help - I'm working on getting the Raspberry setup

I also run Octopi on a Raspberry Pi 3 with my M2. A few days ago, I made a further upgrade that you might find interesting. I added the following bits to give it a local display, so I don't need to drag over a laptop or log in with my phone to do basic things like filament changes, shutting down the Pi, etc:

• 7" LCD touchscreen
• SmartiPi Touch case

For the local controls, I installed the TouchUI plugin, and set up boot to browser.

Nice.. I just bought a 7" display to try and do this too... I think it's a generic display so hopefully I can use the same links to get it to work.

-Steve