Page 1 of 1

M2 Dual vs M3

Posted: Thu Aug 24, 2017 5:18 am
by DonGar
I'm ready to upgrade from my current low end printer, and have heard nothing but good things about MakerGear.

My default is to get the M3 as the newer / better design. But I'm also really excited about the idea of using the second extruder for PolySupport or some similar material. Sadly, the M3 Dual is a bit out of my price range.

What do people recommend?

Does PolySupport work as well as I'm hoping?

Is it reasonable to get an M3, and hope for a dual upgrade kit at some point?

Re: M2 Dual vs M3

Posted: Thu Dec 28, 2017 1:56 pm
by Bernie X
Found this while searching for PolySupport. I was facing the same conundrum, and ended up with the M2 Dual. What did you end up going with?