About Simplify 3D version 4.0 and M2 Rev. E

[Expresso]

Hello,

I currently use Simplify 3D version 3 and have been thinking of upgrading to Simplify 3D version 4. Before I go ahead with the upgrade, I was wondering if someone else has already upgraded to the new version and if they wouldn't mind sharing their experience with the new version.

If at all possible I would rather avoid upgrading if it means I have to fiddle around with the printer and other configuration issues. I would much prefer a plug and play experience free of issues. Specifically, I would like to know if Simplify 3D version 4 plays nice with the M2 Rev. E printer.

Thanks.

[willnewton]

It’s fine. Not much else to say. It was not a life changing upgrade or anything like that.

[sthone]

I believe every time you do an upgrade of S3D it does a new install so the old version is still there too.