Filament Drive Gear Worn Out by Carbon Filament
Posted: Sun Nov 26, 2017 5:29 pm
Hello all, the Subject says it. I can post a photo if there's interest, but my drive gear has a nasty groove worn into it since starting to use carbon-filled filaments with regularity. Incidentally, I already switched to this (https://www.3dxtech.com/makergear-m2-he ... el-nozzle/) hardened nozzle, as the stainless one from Makergear seemed to be wearing.
I'm posting this mainly so Makergear knows that if a hardened drive gear were to exist, at least one person would buy one.
~Justine
I'm posting this mainly so Makergear knows that if a hardened drive gear were to exist, at least one person would buy one.
~Justine