Post production media blasting

General discussion topics
Post Reply
User avatar
Posts: 4
Joined: Tue Jan 19, 2016 11:46 pm

Post production media blasting

Post by Takayuki » Sun May 06, 2018 7:38 pm

Has anyone tired post production of PLA by media blasting the surface with plastic beads? I've finished several PLA prints that involved hours of dry sanding / wet sanding to achieve a slick surface for paint, but wondered if media blasting might reduce the overall sanding time.

Thanks in advance.

User avatar
Posts: 477
Joined: Wed Apr 09, 2014 8:32 pm

Re: Post production media blasting

Post by willnewton » Mon May 07, 2018 12:28 pm

I haven’t tried it, but I do have an abrasive blast cabinet. It uses sand, not plastic though. I wonder what will happen. I suspect it will shred the print, but will try it on something.

In the meantime, you may want to try this. It works very well.
I'm finally back to where I started two days ago!

A thread with some stuff in it I update every once in a while. viewtopic.php?f=8&t=9
See some of my stuff

Post Reply