IGLIDE PF filament (and print quality)
Posted: Tue Jul 24, 2018 9:10 pm
Does anyone have experience and advice for using the PF filament?
I do have the recommended mat for adhesion.
I have an M2 with a V4 upgrade Using Simplify 3d
I'm going to be printing these small parts. The actual printing will be from separate stl files which I continue to modify in small ways
I have already printed a PLA version that seems like it will work
The "shafts" shown will actually be Stainless steel
They will automatically close 3/4" thick small doors that have been opened 170°in museum displays
The curved surfaces will be friction/wear points so I'm trying to get the best quality that I can especially on the top shell.
Any helpful advice on this?
I do have the recommended mat for adhesion.
I have an M2 with a V4 upgrade Using Simplify 3d
I'm going to be printing these small parts. The actual printing will be from separate stl files which I continue to modify in small ways
I have already printed a PLA version that seems like it will work
The "shafts" shown will actually be Stainless steel
They will automatically close 3/4" thick small doors that have been opened 170°in museum displays
The curved surfaces will be friction/wear points so I'm trying to get the best quality that I can especially on the top shell.
Any helpful advice on this?