Bed Heater Wire Clamp Model

General discussion topics
Post Reply
M3Jim
Posts: 19
Joined: Sat Jun 13, 2015 2:16 pm
Location: FL

Bed Heater Wire Clamp Model

Post by M3Jim » Thu Jul 26, 2018 10:43 pm

Hi All,

I want to make a wire guide for the bed heater wires that changes the wire direction 90deg downward. The direction, going straight out the back is running into the enclosure I am building. Is there a model anywhere of the clamp for the wires that attaches at the back of the bed? I started measuring, but ran out of time today. So while I wait for some time tomorrow, I thought I would see if I could make my life easier by checking for a CAD model that I could just import and subtract from a block to get my basic model.

Sorry, I just noticed I may have posted on the wrong forum. If you would prefer this in the modifications forum, could you please move it?

Have a great day,
Jim

Post Reply