Glass Pop
Re: Glass Pop
Wow,That PETG can really stick to the build surface. I have destroyed a PEI surface by starting too close to it.
Re: Glass Pop
there was a guide about printing PETG here somewhere and it warned to give more space for first layer as it is very sticky
Re: Glass Pop
It's all good, been printing petg for a long time but not on clean glass.. Normally have the glass covered with tape or glue stick.. lesson learned.. Going to try filling that chip with epoxy ..
-
- Posts: 100
- Joined: Sat Apr 19, 2014 8:34 pm
Re: Glass Pop
That happened to me with a PLA print (about 1"x3" base) using just hair spray. The bed was a little over two years old and regularly flipped.