General discussion topics
4 posts • Page 1 of 1
I have only done this, I think twice with my M2. I prepped the end of the running out filament by cutting the end square. I got the new filament ready and as the running out filament got an inch or 2 from the extuder housing, I slid the new piece into the tube and removed the tube from the extrtuder housing so I would have better control of the filament end. As the original descended into the housing I pushed the new in right behind.. took a few seconds get get in in the hole so I ended up with a very slight under extrude for a short time but the part was fine when complete.