Thomas Sanladerer interviewed Slice Engineering about the Mosquito Hotend at MRRF2019. They present it mounted on a MG printer. Nice!
https://www.youtube.com/watch?v=OIWaVJwuihY&t=335s
Makergear cameo shot on youtube
- willnewton
- Posts: 479
- Joined: Wed Apr 09, 2014 8:32 pm
Makergear cameo shot on youtube
I'm finally back to where I started two days ago!
A thread with some stuff in it I update every once in a while. viewtopic.php?f=8&t=9
See some of my stuff http://www.thingiverse.com/willnewton/favorites
A thread with some stuff in it I update every once in a while. viewtopic.php?f=8&t=9
See some of my stuff http://www.thingiverse.com/willnewton/favorites
Re: Makergear cameo shot on youtube
Thanks for posting! Chris from Slice sent us a link to the video. I asked him to send us a hot-end to test...
Rick
Rick
Re: Makergear cameo shot on youtube
I may be mistaken, but it looks like the Mosquito Hot End is really intended for a bourden drive printer. I emailed these guys and learned that they couldn't mount their really slick heat-sink setup on the M2 because the filament drive was in the way. So they left it off.
My question then would be "Is there any reduction in the capabilities of your hot end system when it is incomplete?"
My question then would be "Is there any reduction in the capabilities of your hot end system when it is incomplete?"