Page 1 of 1

Makergear cameo shot on youtube

Posted: Tue Apr 02, 2019 10:22 pm
by willnewton
Thomas Sanladerer interviewed Slice Engineering about the Mosquito Hotend at MRRF2019. They present it mounted on a MG printer. Nice!

https://www.youtube.com/watch?v=OIWaVJwuihY&t=335s

Re: Makergear cameo shot on youtube

Posted: Wed Apr 03, 2019 5:27 pm
by rpollack
Thanks for posting! Chris from Slice sent us a link to the video. I asked him to send us a hot-end to test...

Rick

Re: Makergear cameo shot on youtube

Posted: Mon May 20, 2019 6:07 pm
by jferguson
I may be mistaken, but it looks like the Mosquito Hot End is really intended for a bourden drive printer. I emailed these guys and learned that they couldn't mount their really slick heat-sink setup on the M2 because the filament drive was in the way. So they left it off.

My question then would be "Is there any reduction in the capabilities of your hot end system when it is incomplete?"