Peek tube into extruder housing assembly questions

Post your advice, tips, suggestions, etc...
Post Reply
Wayneswift
Posts: 13
Joined: Fri Apr 11, 2014 2:28 am

Peek tube into extruder housing assembly questions

Post by Wayneswift » Sat May 10, 2014 6:29 pm

Doing a bit of maintenance on my beloved M2 and wondering the correct way to assemble the hot end and to keep it from rotating. Have had issues with it rotating at temperature and with extruder stopping and discovered that there was residue in the brass tube. What are the SS pins for and is there a retainer that actually holds the peek tube in place, also the brass tube is supposed to go into the peek as far as it can? Thanks again for this unbelievably incredible group and an equally unbelievably incredible product.

Wayneswift
Posts: 13
Joined: Fri Apr 11, 2014 2:28 am

Re: Peek tube into extruder housing assembly questions

Post by Wayneswift » Sat May 10, 2014 8:29 pm

Found what I was looking for on google forum. Sorry for jumping the gun!

Post Reply