Page 2 of 2
Re: Kinda-sorta enclosed build area for ABS
Posted: Sun Sep 13, 2015 1:21 pm
by loiphin
jsc: Thanks, but its actually a DC power supply
Re: Kinda-sorta enclosed build area for ABS
Posted: Sat Sep 26, 2015 8:42 am
by shawnrw
Loiphin,
What IKEA enclosure is that it looks bigger than most?
Thanks,
Shawn
Re: Kinda-sorta enclosed build area for ABS
Posted: Fri Oct 30, 2015 1:13 am
by Lokespop
CCVirginia asked about enclosures...
I wanted to experiment with an enclosure when a thermometer off to the side of my M2 indicated I was experiencing 6 degree F variations in my surrounding environment. After looking for a makeshift enclosure, I finally hit on the idea to use the shipping box which protected my M2 from harsher environs. I put the box on its side, extended a flap so it, too, was on the same surface as the box. Sliding in the printer, I had room for heat to escape easily, but the three-sided enclosure seemed to stabilize the build area temp nicely. My printer is now in a more protected area, so the box is no longer needed. 'Hope this helps...
Lokespop
Re: Kinda-sorta enclosed build area for ABS
Posted: Thu Feb 11, 2016 7:06 am
by clm7214
loiphin wrote:Just get a cheap IKEA cabinet and IKEA LED light setup and be done with it. Easy and looks nice.
What IKEA cabinet is that? That's exactly what I'm looking for.