Beginner's Guide to Getting Started with the MakerGear M2
Posted: Sun Feb 07, 2016 6:38 pm
Many, many thanks to everyone who helped with suggestions and the editing on this thing, it is much appreciated!
This is a 26 page, detailed guide that will hopefully direct newcomers to everything they need to be able to find without having to spend all day searching for it. It also spells out a couple of the more important Settings procedures, for those who are brand new and a bit hesitant. (Lot of the information in it also appears in the Getting Started guide - this has been expanded for beginners and non-techie folk.)
(And i hope it will be a little easier to follow given the limitations of the forum format.)
Note: If you have the new M2 V4 Rev.E Printer, (shipping after 3/1/16), this guide is not geared to your printer. A new guide has been prepared for your machine, and has been placed in the "How To" section.
M2 Rev.E Beginner's Guide: viewtopic.php?f=3&t=3542.
Okay insta, handing off to you. (Hope you got all those matrices ready!) Whew!
This is a 26 page, detailed guide that will hopefully direct newcomers to everything they need to be able to find without having to spend all day searching for it. It also spells out a couple of the more important Settings procedures, for those who are brand new and a bit hesitant. (Lot of the information in it also appears in the Getting Started guide - this has been expanded for beginners and non-techie folk.)
(And i hope it will be a little easier to follow given the limitations of the forum format.)
Note: If you have the new M2 V4 Rev.E Printer, (shipping after 3/1/16), this guide is not geared to your printer. A new guide has been prepared for your machine, and has been placed in the "How To" section.
M2 Rev.E Beginner's Guide: viewtopic.php?f=3&t=3542.
Okay insta, handing off to you. (Hope you got all those matrices ready!) Whew!