settings for PLA printing part at .050mm
- wisdomknight
- Posts: 103
- Joined: Sun Apr 10, 2016 9:10 pm
settings for PLA printing part at .050mm
Right now Im using the black PLA that came packed with the M2.
Temperatures 220 extruder and 70 bed (hairspray)
Im trying to print a part at .050mm.
What is the recommended settings for something at this resolution?
It starts off good then either starts pullin off bed after a couple minuted or becomes a mess.
I have a .35mm nozzle and I can print successfully at .100mm or higher but thats it
Any help would be appreciated.
Temperatures 220 extruder and 70 bed (hairspray)
Im trying to print a part at .050mm.
What is the recommended settings for something at this resolution?
It starts off good then either starts pullin off bed after a couple minuted or becomes a mess.
I have a .35mm nozzle and I can print successfully at .100mm or higher but thats it
Any help would be appreciated.
- wisdomknight
- Posts: 103
- Joined: Sun Apr 10, 2016 9:10 pm
Re: settings for PLA printing part at .050mm
ok went up to .100mm and still popping off bed after a few minutes
- wisdomknight
- Posts: 103
- Joined: Sun Apr 10, 2016 9:10 pm
Re: settings for PLA printing part at .050mm
would the tape be better at these resolutions?
- wisdomknight
- Posts: 103
- Joined: Sun Apr 10, 2016 9:10 pm
Re: settings for PLA printing part at .050mm
reduced temps to 190 and 45, same thing starts off with perfect layeres.
Then after a couple min starts popping off everywhere, way worse at these lower temps!
Then after a couple min starts popping off everywhere, way worse at these lower temps!
Re: settings for PLA printing part at .050mm
Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.
Custom 3D printing for you or your business -- quote [at] pingring.org
- wisdomknight
- Posts: 103
- Joined: Sun Apr 10, 2016 9:10 pm
Re: settings for PLA printing part at .050mm
now tried 220 and a 75 bed.
way better hotter but still starts coming off .
done for the day.
way better hotter but still starts coming off .
done for the day.
- wisdomknight
- Posts: 103
- Joined: Sun Apr 10, 2016 9:10 pm
Re: settings for PLA printing part at .050mm
the nozzle?insta wrote:Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.
Re: settings for PLA printing part at .050mm
Yep. Set your first layer height to 400% or so.wisdomknight wrote:the nozzle?insta wrote:Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.
Custom 3D printing for you or your business -- quote [at] pingring.org
- wisdomknight
- Posts: 103
- Joined: Sun Apr 10, 2016 9:10 pm
Re: settings for PLA printing part at .050mm
thank you I will try!
- wisdomknight
- Posts: 103
- Joined: Sun Apr 10, 2016 9:10 pm
Re: settings for PLA printing part at .050mm
Working great now!insta wrote:Yep. Set your first layer height to 400% or so.wisdomknight wrote:the nozzle?insta wrote:Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.
Thank you soo much!