settings for PLA printing part at .050mm

[wisdomknight]

Right now Im using the black PLA that came packed with the M2.
Temperatures 220 extruder and 70 bed (hairspray)

Im trying to print a part at .050mm.

What is the recommended settings for something at this resolution?

It starts off good then either starts pullin off bed after a couple minuted or becomes a mess.

I have a .35mm nozzle and I can print successfully at .100mm or higher but thats it

Any help would be appreciated.

[wisdomknight]

ok went up to .100mm and still popping off bed after a few minutes

[wisdomknight]

would the tape be better at these resolutions?

[wisdomknight]

reduced temps to 190 and 45, same thing starts off with perfect layeres.
Then after a couple min starts popping off everywhere, way worse at these lower temps!

[insta]

Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.

[wisdomknight]

now tried 220 and a 75 bed.
way better hotter but still starts coming off .

done for the day.

[wisdomknight]

Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.

the nozzle?

[insta]

Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.

the nozzle?

Yep. Set your first layer height to 400% or so.

[wisdomknight]

thank you I will try!

[wisdomknight]

Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.

the nozzle?

Yep. Set your first layer height to 400% or so.

Working great now!
Thank you soo much!