I just switched from PLA to ABS and nothing coming thru extr

[Jules]

There's a lot of really good information in the Filaments forum, particularly in the thread below:

viewtopic.php?f=11&t=1951

It will save you time and wasted filament.

[thunderbt3]

Thats good to know. It frustrating learning these particular setting.
Thanks again

BTW is ABS safe, the fumes? I opened the window because of this.
But its too cool for it unless I close the window behind the printer

http://pubs.acs.org/doi/pdf/10.1021/acs.est.5b04983

[Jules]

Most of the folks who are concerned about the effects of long term exposure to ABS just print PETG instead.