There's a lot of really good information in the Filaments forum, particularly in the thread below:
viewtopic.php?f=11&t=1951
It will save you time and wasted filament.
I just switched from PLA to ABS and nothing coming thru extr
-
- Posts: 105
- Joined: Wed Apr 09, 2014 11:36 pm
Re: I just switched from PLA to ABS and nothing coming thru
http://pubs.acs.org/doi/pdf/10.1021/acs.est.5b04983wisdomknight wrote:Thats good to know. It frustrating learning these particular setting.
Thanks again
BTW is ABS safe, the fumes? I opened the window because of this.
But its too cool for it unless I close the window behind the printer
Re: I just switched from PLA to ABS and nothing coming thru
Most of the folks who are concerned about the effects of long term exposure to ABS just print PETG instead.