Print interruped
Posted: Sun May 22, 2016 9:03 pm
I was printing from my SD card and know that you can pull out your USB cable and it will print on its own, I have done this a few times already.
I was printing a part, about 80% finished, and I quit S3D and closed my MacBook before taking out the USB Cable and the printer froze.
I tried to turn it back on and resume but couldn't figure out how.
Has anyone else had this problem?
Is there a way to resume a print that got interrupted by loss of power or accidentally quitting?
Thanks
I was printing a part, about 80% finished, and I quit S3D and closed my MacBook before taking out the USB Cable and the printer froze.
I tried to turn it back on and resume but couldn't figure out how.
Has anyone else had this problem?
Is there a way to resume a print that got interrupted by loss of power or accidentally quitting?
Thanks