How to restart an incomplete print

Post your advice, tips, suggestions, etc...
Post Reply
psd
Posts: 203
Joined: Tue Mar 08, 2016 9:09 pm

Re: How to restart an incomplete print

Post by psd » Tue Jan 31, 2017 1:07 am

In the end, I realized its just best to clear the build plate and reprint minus what was printed.
Too bad I haven't found a decent solvent for PETG yet. Superglue still best bonding method.
thanks all
- peter,

innovative product designer and tinkerer

www.petersolomondesign.com
Top
Bratag
Posts: 438
Joined: Wed Jan 14, 2015 5:33 am

Re: How to restart an incomplete print

Post by Bratag » Tue Jan 31, 2017 3:44 pm

I use WeldOn (number 4 I think) for gluing PETG parts. Its a pain in the ass to work with as its runny but get yourself a couple of smaller squeeze bottles with micro tip applicators and you will be fine. I get very good bonding.
Top
Post Reply

Return to “How-to/Guides/Tips”