Filament Strips Out and Jams at Specific Z Height
Posted: Tue Feb 28, 2017 11:51 pm
Hi. Long time listener, first time caller.
I've had my machine for a few years now but it is up to date as far as firmware, 24V PS, and I run a V4.
Basically the Subject nails it. Third print in a row dies at the same layer from a jammed extruder. I've checked how deep my extruder is biting and there is nothing indicative left on the print or nozzle to help me out. The print quality is great. I'm running Esun's PETg using Jules' write up and most of her recommended settings. (Awesome write up) I've run three of these to completion and now I am stuck.
What am I not looking at that would cause a jam at a given layer height like this? I'll mention that this spool is running thin at about a 1.65mm OD but that's accounted for in my Extrusion Multiplier.
Suggestions would be most welcomed. Thank you.
https://ibb.co/f9hurF
https://ibb.co/mEkfWF
https://ibb.co/cQGLWF
I've had my machine for a few years now but it is up to date as far as firmware, 24V PS, and I run a V4.
Basically the Subject nails it. Third print in a row dies at the same layer from a jammed extruder. I've checked how deep my extruder is biting and there is nothing indicative left on the print or nozzle to help me out. The print quality is great. I'm running Esun's PETg using Jules' write up and most of her recommended settings. (Awesome write up) I've run three of these to completion and now I am stuck.
What am I not looking at that would cause a jam at a given layer height like this? I'll mention that this spool is running thin at about a 1.65mm OD but that's accounted for in my Extrusion Multiplier.
Suggestions would be most welcomed. Thank you.
https://ibb.co/f9hurF
https://ibb.co/mEkfWF
https://ibb.co/cQGLWF