Hello,
I have played with my settings so much for PETG, that I am now getting bad quality under any supports and bottom layers that are not in contact with the bed.
does anyone have specific support settings that could help or should I just go back to the initial PETG settings Jules posted and zero everything out?
thanks!
bad underside quality on PETG prints
Re: bad underside quality on PETG prints
IMHO, the most significant factor in support/part interaction is layer thickness. I always use one separation layer top and bottom.
If supported build is sloppy, reduce layer thickness.
If bond between support and the part is excessive, increase your layer thickness.
If supported build is sloppy, reduce layer thickness.
If bond between support and the part is excessive, increase your layer thickness.