Page 1 of 1

PEI Surface - which thickness?

Posted: Sat Aug 26, 2017 1:13 pm
by Evan
Hi All,

I am looking at replacing the kapton my M3 shipped with with a sheet of PEI. Looking at the various sizes etc. I see there are also a few thicknesses available. I was hoping to get some advice on which thickness of PEI to apply to my M3 glass bed? Or does it not really matter? I see prusa research have quite a thin PEI available, which is almost a perfect size (only just a little larger) for the M3 build platform, with adhesive applied. Would this suit, or should I got with a thicker piece? Thanks.

Re: PEI Surface - which thickness?

Posted: Sun Aug 27, 2017 12:29 am
by sthone
A lot of us on the forum are using these sheets and attaching them with 3M Tape.

I find I have to change the adhesive tape now and then but the PEI sheets last a long time.

Re: PEI Surface - which thickness?

Posted: Mon Aug 28, 2017 4:48 am
by Evan
Thank you sthone!