1 inch cube
Posted: Mon Sep 08, 2014 7:23 pm
I printed this out today just out of curiosity:
http://www.thingiverse.com/thing:37869
Got the following measurements on a Mitutoyo CD-8"PSX Micrometer
X axis - 0.9990" x 0.2495" x 0.2485"
Y axis - 0.9930" x 0.2495" x 0.2470"
Z axis - 1.001" x 0.2485" x 0.2475"
I'm guessing that's pretty darn close, but curious what settings would I have to adjust if these were to ever be off?
http://www.thingiverse.com/thing:37869
Got the following measurements on a Mitutoyo CD-8"PSX Micrometer
X axis - 0.9990" x 0.2495" x 0.2485"
Y axis - 0.9930" x 0.2495" x 0.2470"
Z axis - 1.001" x 0.2485" x 0.2475"
I'm guessing that's pretty darn close, but curious what settings would I have to adjust if these were to ever be off?