UN-solved: Need a S3D GCODE
Posted: Fri Jul 31, 2015 1:15 pm
GCode Delivered, Thanks Jules!
I want to print a new filament drive, but Slic3r is letting me down with support generation. Could someone be kind enough to run the Attached filament drive through S3D for the following specs:
Stock M2 V3B with fan duct, binder clips on HBP
esun PETG Black
1.78mm
1.05 multi
250C Hot End Temp (first layer and on)
100C Bed temp
0.25 Layer Height (first layer and on)
0.4 Extrusion Width (all)
90% linear infil (unless if you recommend otherwise.)
Conservative speeds (75 Infil 50 for others and below for fine print.)
-0.05 Z Offset
1mm retraction
60mm/s retract speed
Let me know if you need anymore info.