Page 1 of 1

Kinematic mirror mount

Posted: Fri Aug 01, 2014 11:51 pm
by davidb
A test print to see whether I can make usable optomechanics - looking very promising thus far ...
(216.35 KiB) Downloaded 710 times

Re: Kinematic mirror mount

Posted: Mon Aug 04, 2014 2:57 am
by chad
I've done some experimenting here too. Long term stability isn't going to be 6061 but if you don't mind tweaking a little more should work for test stuff.
Hell of a lot cheaper than thor for proving out ideas.
First pic you can see some flexure mounts that I machined (red) and printed. (upper right three) and some little optics test parts.
Next is test rig for a scanning Grating spectrometer. Needed some odd parts, could machine them, printed them instead.. Worked great!