ABS Mold

jdacal · Post by **jdacal** » Wed Oct 29, 2014 6:06 am

Ok, here's the "Team MakerGear" version. I went ahead and ordered a .50 nozzle, nobody seemed to have the .40 in stock. Anyway came out much heftier now after following the suggestions, thanks for the help! :

: 2014-10-29 00.56.50_1.jpg (180.23 KiB) Viewed 5532 times

: 2014-10-29 00.57.06_1.jpg (149.07 KiB) Viewed 5532 times

insta · Post by **insta** » Wed Oct 29, 2014 2:51 pm

Just for S&G, can you put the 0.35mm nozzle back on, and slice that part with the new version of Slic3r? It has a feature, some kind of adaptive infill, that will pump up the extrusion width for cases like you had. I'm curious if it'll work here.

jsc · Post by **jsc** » Wed Oct 29, 2014 5:12 pm

Here's what it looks like sliced with Slic3r.

jdacal · Post by **jdacal** » Wed Oct 29, 2014 5:17 pm

insta wrote:Just for S&G, can you put the 0.35mm nozzle back on, and slice that part with the new version of Slic3r? It has a feature, some kind of adaptive infill, that will pump up the extrusion width for cases like you had. I'm curious if it'll work here.

Hi insta, I haven't receive the .50 nozzle yet. I did that with S3D by adjusting the extrusion width. I've never used Slicer yet, but may try it later tonight and let you know how it turns out.

ABS Mold

Re: ABS Mold

Re: ABS Mold

Re: ABS Mold

Re: ABS Mold