No worries, When I'm printing from the G-Code Library from the Machine Control Panel is that still printing from the SD Card?
-Steve
Got the Time? (Clock)
Re: Got the Time? (Clock)
Last edited by sthone on Sun Mar 29, 2015 5:01 am, edited 1 time in total.
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com
See my projects at https://www.theneverendingprojectslist.com
Re: Got the Time? (Clock)
No, that is sending g-code directly through USB. M25 is interpreted by the firmware; M0 is caught by the host (the thing doing the sending during USB prints).
Re: Got the Time? (Clock)
I think the first time I tried it with the M0 I was printing through USB from the G-Code Library and that's when it didn't stop. I'll give it a try tomorrow again just to be sure though.
-Steve
-Steve
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com
See my projects at https://www.theneverendingprojectslist.com